Dingy behind, I'm thinking 'NO' , theft, locking, bouncing around while planing ,no access to swim platform & ladder !
A cradle extended from the upper hand-rails ,will support the dingy and solar water panels , over the enlarged rear deck.
The centre down-stairs roof support [back scratching] pole has been installed to be the bottom mast support,
fabricate an upper mast head,C/W -circular stand up wet bar, and extend hand-rails to support an ,
Over Head Cantilevered Davit Arm, extendable to 9Ft., with capacity of 1100Lbs/5Kgs ,similar to pic #1
ours will mount in the centre /middle of the upper deck, with 180 Deg. swing rotation, without restriction.
many different lifting devices here ;
http://www.nauticexpo.com/boat-manufact ... 22753.html
- what are the pro's and cons ?
===============================================================================
I want to lengthen/enlarge the rear deck 30"for extra room & motorcycle parking, similar to pic #2
extend hand rails upward,cradling the 7Ft. dingy length ways, upside down, pointing forward,
with 3Ft.X 6Ft. solar-water-panels mounted on either side, making a roof. [ maybe it will look like a planes tail ? ]
suspend a swim-platform below it , C/W - trim tabs and, small transom, out board mount
- again what are the pro's and cons ?
================================================================================
pic # 3 -
I intend to complete these plans , 2014-2015 and build/ install 2016-2017